NanoVNA Firmware Update: H and H4, Step by Step



A white screen on a NanoVNA after you start a firmware update looks dead. It isn’t: that’s DFU (update) mode. I update my NanoVNA-H from DiSlord 1.2.20 to 1.2.46 with STM32CubeProgrammer, then show what’s different on the H4, including the “Unknown device” problem in Windows and how I fixed it.

In this video:
– Check your firmware version first: CONFIG → VERSION
– Two ways into DFU mode on the H (the menu, or hold the jog wheel while you power on)
– The right file: NanoVNA.H… for the H, NanoVNA.H4… for the H4 (different chips)
– STM32CubeProgrammer: connect over USB and flash the firmware
– Calibrate again and save it after the update
– The H4: it shipped newer than GitHub, and its menu DFU showed “Unknown device”
– The fix: power-button DFU mode, or the WinUSB driver

Chapters
0:00 Intro
0:18 Check your version first
0:50 Two ways into DFU mode
1:54 Download the firmware
2:27 Install STM32CubeProgrammer
3:18 Connect in DFU mode
3:49 Flash the firmware
4:39 Recalibrate and test
5:18 The H4: newer than GitHub
6:09 H4: “Unknown device” fix
7:56 Wrap-up

Firmware (free, open source):
STM32CubeProgrammer (free, from ST):
Calibration, step by step:
NanoVNA-H vs H4:
Screen mirroring in this video:

The two analyzers in this video (affiliate links):
NanoVNA-H:
NanoVNA-H4:

As an Amazon Associate I earn from qualifying purchases.

Driver note: the WinUSB/DFU driver installs with STM32CubeProgrammer from the ST link above. If Windows still shows “Unknown device,” reinstall it and reconnect in DFU mode.

The H is mine. The H4 was lent to me and goes back; nobody paid for this video.

73, KK4G

#hamradio #NanoVNA #firmware

source

1 Comment

  1. What firmware is yours running? CONFIG > VERSION. Mine went from 1.2.20 to 1.2.46, and the H4 came from the factory with 1.2.50. Oldest one wins.

Leave a Reply

Your email address will not be published. Required fields are marked *

You might like

© 2026 Cantinho do Vídeo - WordPress Video Theme by WPEnjoy