I built a VARIABLE ROCKET NOZZLE



GIVE ME YOUR IDEAS:

Slow motion Camera:

Machines
Prusa Mk4:
Carvera CNC:
Form 4 (Resin):

#rocket #engineering #3dprinting

source

23 Comments

  1. for the video idea, you can make a version of a jetpack / suit similar to the one done by gravity industries or Jlazar. If thats not a good idea, you can use one of your engines to try and send a small satellite to space..?

  2. 8:54 So once upon a time, I worked up north in Canada. One night the temperature dropped below minus 53 C, so the propane for the camp and rig furnaces stopped vaporising. We (meaning me, the medic) had to put a 20 lb propane tank in the engine compartment of a water truck to warm it up. Then I hooked a tiger torch to it, and proceeded to flame the 500 lb tanks for the furnaces. Whenever my flame started shrinking, I'd flame my 20 pounder to push the pressure back up.

    I see your hair dryer and raise you a tiger torch 😛

  3. 3 years ago I put a comment on your video: "How about an adjustable aperture nozzle? And have a sensor which auto-adjusts it based on the pressure." If I give you another idea will you take 3 years to get around to it? :p

  4. with real concern i am writing this comment, graphite despite being super cool have a problem of becoming dust and as we know it is conductive it will get into electronics and it may make funny expensive sounds and if it goes in lungs it may cause lung ouchies sooo please wear a mask around it especially when it is as dust.

  5. I realy really want more steamturbine videos or compressed air batteries as an energy storage.

    Both idea could also use Solar thermal energy as a heat source

  6. Hey integza, I’m trying to recreate your jet engine project, but I’m not sure what size brass tubing you used for transportation of the fuel. Could you tell me the OD? Thanks.

Leave a Reply

Your email address will not be published. Required fields are marked *

You might like

© 2026 Cantinho do Vídeo - WordPress Video Theme by WPEnjoy